How to Configure WiFi for wiTech MicroPOD2?

Let me get straight to the point. Here is the WiFi setting guide of the new released WiFi version wiTech MicroPod 2 V17.04.27 diagnostic scan tool for Chrysler Jeep Dodge and Fiat.

 

 

 

How to configure a Wireless Profile on a MicroPOD2?

Preparation:

On a PC with the wiTECH V17 software application installed

Iwifi version share the same installation procedure as non-wifi version micropod2.

Check: http://blog.obdii365.com/2017/07/25/install-witech-micropod-2-v17-04-27-on-windows-7/

 

 

Then plug MicroPod II interface into the OBD2 port of your vehicle. The indicator will turn green, it means it car is charging the device.

Meanwhile use the USB cable to connect one laptop (Dell, Lenovo etc) with installed V17.04.27 wiTech software

Connect wireless WIFI on the computer.

Enter IP “172.22.22.22” into the address bar of an Internet browser.

This opens the Witech setting interface

Select “Wireless Settings” in the menu on the left

 

Profile is set to “Default”.

 

Click on “Save”.

 

Wireless Settings saved. To enable this wireless profile, click on “Manage Networks”.

You can close this page and return to configuring the device by clicking on the close button below.

Next operation is to click on “Manage Networks” -> Wireless (tick it off) -> Select & Start.

Once the connection is complete you will see an IP address populate for the wireless interface

Success, close it.

Back to click on “Manage Networks”,  now we can see “Currently Selected”, and 172.22.22.22 is enabled, which means the wireless connection is set successfully.

 

Video reference:

 https://youtu.be/cfpQFpkwVV8

 

V17.04.27 wiTech MicroPod2 Wifi setting is done successfully.

https://www.obdii365.com/service/set-up-wifi-connection-on-micropod-2.html